Scantronic 4603 Manual de instalación descargar pdf (Pagina 6)

6 of 34 496372 Issue 1

Re-assembly

Refit the lid of the case, ensuring that the aerial cord is firmly gripped in the

guides provided and that the sealing “O” ring is correctly seated. Replace the

cross-headed screws into the holes and firmly screw the case together. It is

essential that the screws are tightly secured as the water-resistance is

dependant on this. If necessary, re-seal the aerial Entry/Exit point, with

DOW-CORNING sealant REF: RTV 3145.

ON NO ACCOUNT USE AN ACETIC-ACID BASED SEALANT. (Acetic acid

sealants have a vinegar-like smell).

CAUTION: After accidental immersion in any liquids, the unit should be

opened (as described above), the transmitter board removed

and the whole unit allowed to dry. When completely dry the

unit should be re-assembled, the case re-sealed (as described

in the previous paragraph) and the whole unit tested for correct

operation and range.

If the unit accidentally drops into non-liquid food substances, it

can be carefully wiped clean with a damp cloth. Under no

circumstances should it be washed under running water or

immersed in water or a cleaning fluid.

4602

Introduction

The 4602-55 can be used as a personal attack transmitter to provide remote

protection.

To operate, press the two orange side buttons together. The transmitter does

not signal if you press only one button. Note the black button fitted below the

left-hand orange button. This is a safety lock to prevent false activations.

Slide the black button upwards to lock the orange button.

Technical Specification

Dimensions (body) h x w x d 102 x 44 x 20mm.

Input supply 3.7V Lithium battery.

Frequency 173.225 MHz.

Output power 1mW.

Operating temperature -10° to +55°C. Humidity up to 80% (non

condensing).

Fully DTI approved to MPT1344. No licence required. For use in

BS6799:1986 systems classes 1-3.

4602

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Sin comentarios

Scantronic 4603 Manual de instalación Pagina 6