Scantronic 4603 Manual de instalación descargar pdf (Pagina 13)

496372 Issue 1 13 of 34

Mode 3 - Boat/caravan Single Zone Alarm Panel

In this mode the 4603-60 can be used as a boat or caravan single zone

alarm panel, which transmits alarm conditions to a remote on-site monitoring

centre.

Place Mode 1 switch ON, Mode 0 switch OFF.

Connect normally closed sensing device between A and Gnd (for example a

movement sensor).

Connect normally closed tamper loop between B and +Ve.

Connect arming switch (key switch or similar) between I/P Con and +Ve.

Figure 8. 4603 Boat Caravan Mode

The 4603-60 is disarmed with the keyswitch ON. While disarmed the unit

monitors input B continuously (24 hour tamper zone) and ignores input A. If

contact B opens the 4603-60 sends a transmission channel B.

The 4603-60 is armed when the keyswitch is OFF. When the switch opens

the 4603-60 sounds the beeper for a fixed 25 second exit period. At the end

of this period the 4603-60 monitors both inputs A and B. If input A opens the

4603-60 sounds the beeper for the 25 second entry period. Unless the unit is

disarmed by closing the keyswitch during the entry period the 4603-60 then

sends a transmission channel A. At the end of the transmission the 4603-60

re-arms input A.

The 4603-60 can be disarmed at any time by closing the keyswitch.

Coding the Transmitter

Set the radio site code (bank of 8 plus 4 DIP switches) as shown for the

4604. Do not use the las two switches in the bank of 4.

Mode 4 - Alarm/Tamper Transmission, With Restore On

Both Channels (Door Contact)

Place Mode 1 switch ON, Mode 0 switch OFF.

Connect a normally closed sensing loop between A and Gnd.

Connect a normally closed tamper loop between B and +Ve.

Link I/P Con to Gnd.

4603

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Sin comentarios

Scantronic 4603 Manual de instalación Pagina 13