Scantronic 4603 Manual de instalación descargar pdf (Pagina 32)

32 of 34 496372 Issue 1

Note 1. If the transmitter is used for normally closed units, the 4618/9 Receiver must

be in mode 14. Any unused inputs (channels) must be linked out, unless when

using the 4612 or 4660/75.

2. If a normally open input is to be used on channels A and C, then mini-

jumpers J7, J8, J9 and J10 must be removed and mode 15 selected on the

4618/9 Receiver.

Setting Up Modes

4618/9, 4612 & 4660/75 Receivers.

All Inputs normally closed A - D.

1. Fit mini-jumpers J7, J8, J9, J10.

2. Link out any unused inputs, unless using 4612 or 4660/75.

3. Use 4618/9 Receiver Mode 14. The 4618/9 outputs will follow the input

state i.e. open or close.

4618/9 only.

Inputs A and C normally open, Inputs B and D normally closed.

1. Remove mini-jumpers J7, J8, J9, J10.

2. Connect normally open devices to the N.O. terminals on channels A

and C.

3. Use 4618/9 Receiver Mode15. The odd number outputs will be mo-

mentary (5 seconds hold).

4612 only.

Input A is normally open, input B is normally closed.

1. Remove mini-Jumper J7.

2. Connect normally open devices to the N.O. terminals on channel A and

normally closed devices to channel B. Leave channels C and D open.

3. Ensure the 4612 receiver is in two channel mode. Mode switch 6, 7

and 8 on the 4612 are as you select.

Identification Code Selection 4618/9

It is very important when using the 4624 Transmitters that the channel

numbers 1-4, 5-8 are set up correctly. This is decided by using the identifica-

tion code switch number 8 as follows:

a) System Code - switches 1-7 set the same on both transmitter and the

receiver.

b) To allow one 4624 to output to channels 1 - 4 on the receiver, set

switch number 8 on the transmitter to ‘On’.

4624

1 2 ... 27 28 29 30 31 32 33 34

Sin comentarios

Scantronic 4603 Manual de instalación Pagina 32