Scantronic 808 Guía de usuario descargar pdf (Pagina 9)

496235 Issue 1 9

1. Press the A or B keys.

The display shows the zone that is reporting trouble.

2. Press A or B repeatedly until you have seen all the trouble messages.

Note down the zones reported.

3. Press Enter.

The display shows: READY LEAVE

4. Leave via the designated exit route. Close the final door.

Zones giving trouble reports do not affect the system security.

Your alarm system will still work correctly. Contact your alarm

company to let them check the system.

Unsetting the System

If You Have a Keyswitch

Turn the keyswitch to OFF. The system unsets immediately.

Using the Keypad

They system has a programmed entry time. Ask your Installer to make sure

the entry time is long enough for you to enter by the designated entry route,

get to the keypad and unset the system.

The entry time starts when you open the designated door on the entry route.

During the entry time the keypads give a "galloping" entry tone to warn you

that the timer is running. For the last 30 seconds of the entry time the gallop-

ing tone speeds up to warn you that the time is running out.

1. Enter the premises through the designated entry route and go to the

keypad.

As you enter the premises the system starts the entry timer and the

keypad gives the entry tone (a "galloping" tone).

2. Key in your access code at the keypad and press Enter.

The entry tone stops. The system is now unset.

WARNING: If you enter the premises and the keypad is

silent then there may be an intruder.

2. Everyday Operation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Sin comentarios

Scantronic 808 Guía de usuario Pagina 9