Scantronic 808 Guía de usuario descargar pdf (Pagina 15)

496235 Issue 1 15

4. Special Functions

Bell Test

1. Key in your access code.

2. Press Menu followed by 4.

The display shows: 4-TEST OPTNS

3. Press Enter.

The display shows: WALK TEST

4. Press B

The display shows: BELL TST

5. Press Enter.

The system turns the external sounder, strobe, and internal sounder(s)

on for five seconds each, one after the other. While the test is running

the display shows the device that should be operating. At the end of the

test the display shows the date and time.

Note: You can abandon the test at any time by pressing Menu.

Setting the Time and Date (Menu 6)

The end station contains an internal clock/calendar that runs as long as there

is power present (mains or stand-by battery). The system uses this clock to

mark the time and date on the system log. If the power supply fails for any

reason, and the stand-by battery is low, then the system loses track of the

correct time and date. You may also need to change the time if you live in an

area that uses summer/winter time.

To set the time and date:

1. Key in your access code.

2. Press Menu followed by 6.

The display shows: 6-SET TI/DA

3. Press Enter.

The display shows (for example): 26MAR96

Note that one of the characters has a bar

underneath it (called the cursor).

4. Press C or D until the cursor is under the item that

you want to change.

The display shows (for example): 12:18

5. Press A or B to change the numbers to the value

you want.

The display shows (for example): 13:18

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Sin comentarios

Scantronic 808 Guía de usuario Pagina 15