Scantronic 808 Guía de usuario descargar pdf (Pagina 12)

12 496235 Issue 1

4. Special Functions

Introduction

Some users may be allowed to perform a number of other functions, apart

from setting and unsetting the system. These functions are:

Setting the system so that some zones are bypassed or omitted.

Turning the chime function on or off.

Testing the zones and sounders.

Setting the time and date on the system's internal clock.

Changing zone names.

Reading the system log.

To use these functions you must key in your access code and then press

Menu followed by a number. In addition, the alarm system supervisor (see

section 5) must program the system to allow each user access to individual

menu number. The rest of this section assumes that the user has access to

the functions described.

Omitting Zones (Menu + Level)

Your system may be programmed so that you can omit individual zones

when setting the system. This function is useful, for example, if you have to

by pass a detector while decorating. Ask your Installer which zones can be

omitted. Note that omission is not permanent. You must omit the zone every

time you set the system.

To set with a zone omitted:

1. Key in your access code.

2. Press Menu.

The display shows: MENU NO

OR LEVEL

3. Press the Level key for the Level you wish to set.

The display shows: OMIT ZONES

4. Press Enter.

The display shows (for example): HALL

OMIT NO

5. Press A or B until the display shows the zone that you want to omit.

Note that some zones may not be programmed for omission.

6. Press C or D until the display shows the words "OMIT YES".

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Sin comentarios

Scantronic 808 Guía de usuario Pagina 12