Scantronic 808 Guía de usuario descargar pdf (Pagina 10)

10 496235 Issue 1

3. After an Alarm

When your system raises an alarm you must disarm it in order to switch off

the sounders and strobes. The system keeps a record of which zone(s)

triggered the alarms, and shows the zone on the keypad display. Once you

have disarmed the system, the system must be reset before you can start

using it again.

Fire Alarm

The system gives a fire alarm by sounding a warbling tone from the keypads

and inernal alarm sounder. The keypad shows the message:

* FIRE *

LEAVE

1. Evacuate the premises and call the Fire Brigade. Do not attempt to

unset the alarm.

2. When the premises are safe, follow the instructions below.

Disarming the System

1. Go to the keypad via the entry route.

2. Key-in your access code and press Enter.

The sounders go quiet and the display shows: SYS DIS

RST REQ

followed by the cause of the alarm

(for example): ALARM

DINE RM

3. Establish the cause of the alarm and then carry on and reset the sys-

tem.

Resetting the System

The 808 has three different methods for resetting:

Customer Reset. You can reset the system yourself from the keypad.

Engineer Reset. Someone from your alarm company must visit the

premises to reset the system from the keypad.

Remote Reset. Your alarm company will give you instructions over the

phone and a special code so that you can reset the system from the

keypad.

Ask your alarm company what type of reset your system has.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sin comentarios

Scantronic 808 Guía de usuario Pagina 10