Scantronic 808 Guía de usuario descargar pdf (Pagina 20)

20 496235 Issue 1

Changing Access Codes and User Privileges (Menu 8)

You must start from menu 8 for all the facilities described in this section.

To start menu 8:

1. Key in the User 01 access code.

2. Press Menu followed by 8.

The display shows: 8-USER INFO

3. Press Enter.

The display shows: EDIT USR INFO

Changing User Codes

1. Start menu 8.

2. Press Enter until the top line of the display shows "U1-C****".

3. Press A or B until the display shows the user number whose access

code you wish to change.

The display shows (for example): U2-C****

4. Press Enter.

The display shows: U2-C_

5. Key in the four digits of the new user code and press Enter. Note that

the display shows " * " characters instead of numbers. This is to prevent

anyone reading the access code over your shoulder.

The display shows: CONF_

6. Key in the same four digits again.

After you key in the last digit the display

changes to show (for example): U2-DURSN

If the display shows: CODE MISMATCH

then you did not key in the confirmation correctly.

Press Menu and go back to step 4.

If the display shows: CODE IN USE

then another user already has that access code.

Press Menu and go back to step 4.

Setting Up a Duress Code

The system does not allow a user with a duress code access to any of the

special functions listed in section 4. In addition, the system will not let you

give User 01 a duress code.

1. Start menu 8.

2. Press Enter until the top line of the display shows "U1-C****".

5. Supervisor

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Scantronic 808 Guía de usuario Pagina 20