Scantronic 808 Manual de instalación descargar pdf (Pagina 12)

…always there

The other end of this cable must be connected to a good electrical earth.

Failure to fit an earth cable will prevent proper operation of the unit and will

invalidate the warranty.

Replace the TNV circuit cover and secure in position with the screw.

Take the opposite end of the two core telephone cable and strip back both

cores so that 5 mm of wire is exposed. Connect both wires to the redcare

block terminal.

WARNING: the block terminal contains telecommunication network

voltages.

Please note that it is important to use the correct method of connecting the

STU to the BT Block Terminal 92A. The Block Terminal provides an

insulation displacement connection (IDC) block for the incoming phone line.

No connections, other than those made by BT, should be made to this IDC

block. The STU should be connected to the screw terminals as shown.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Sin comentarios

Scantronic 808 Manual de instalación Pagina 12