Scantronic 9800+ Manual de usuario descargar pdf (Pagina 7)

Should the user attempt to set the system with one or more zones open, the

system will not set. The internal sounder will emit an interrupted tone and

the LED display will indicate the open zone, proceed as follows:

Note: If a detector is fitted by the keypad or the final door is known to be

open, the appropriate LED will be displayed. The system will set when clear

of the detection. If the user is not clear by the end of the exit time an exit

fault will occur (internal sounder only).

Enter access code. System returns

to ‘Day’ state. Close open zone.

Reset the system. If no other

zones are open, the system will

set. If other zones are displayed,

repeat steps (a) to (c).

If unable to set call engineer.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

Enter access code. Press ‘A’. Open zone displayed.

‘A’ indicator flashes. Sounder

emits intermittent tone.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

(a) (b)

Setting With Zones Open

- -

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Comentarios a estos manuales

Sin comentarios

Scantronic 9800+ Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Scantronic 9800+