Scantronic 9800+ Manual de usuario descargar pdf (Pagina 23)

System Faults & Alarm Conditions

TELEPHONE LINE FAULT

If your system is fitted with a remote signalling device which operates over

the standard telephone network, a local alarm condition will warn the user if

a telephone line fault exists as follows:

local alarm, entering a valid access code again may clear the

indication. If this is the case, an Engineer will not be required unless a

permanent Lf condition is indicated. You may still be able to set your

alarm system in the normal way, but note that automatic alarm

communication with your alarm company central station will not

operate until the fault has been repaired.

Note: If a line fault condition occurs when the system is set, the system

response will depend on programming of the system during installation.

Either an alarm condition will be initiated, or the system will respond as

above when unset.

Enter valid code.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9