Scantronic 9800+ Manual de usuario descargar pdf (Pagina 13)

On entering the premises the sounder will be emitting a continuous tone. The

user should proceed immediately to the keypad via the prescribed entry route

and unset the alarm as follows:

Note: If unsetting from Part Set, the ‘B’ or ‘C’ LED will be illuminated at

step (a). If zones have been omitted on setting, the omitted zone number will

be displayed at step (a). If a keyswitch is fitted, the system is unset by turning

the keyswitch off.

If the alarm system is not unset before the expiry of the preset entry time, the

internal sounder will change to emit a high pitched tone. You have not

caused a full alarm and still have the time of a second stage timer (30

seconds).

On expiry of the second stage timer, the system will enter into a full alarm

state. If your system is fitted with a remote signalling device, a signal will be

transmitted automatically to your alarm company central station, and the

police authority will be contacted.

IMPORTANT NOTE

If the full alarm condition has been caused by a delay in unsetting the

system and an automatic signalling device is fitted to your alarm system,

you must contact your alarm company immediately in order that the police

call can be cancelled.

Enter access code within the

preset entry time.

System unset.

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

OMITday

Prog log

chime bell-test-walk

POWER

CLEAR

FAULT SERVICE OMIT

9800

1 2 3

4 5 6

7 8 9

(a) (b)

Unsetting the System

- -

Exceeding the Entry Time

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Comentarios a estos manuales

Sin comentarios

Scantronic 9800+ Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Scantronic 9800+