Scantronic 8136 Guía de usuario descargar pdf (Pagina 33)

496256 Issue 1 33

6. Supervisor

4. Press Enter.

The display shows the cursor at the beginning of

the bottom line: U02:P01:

NO ACCESS

5. Press A or B to change access to the Partition.

The display shows (for example): U02:P01:

HAS ACCESS

6. Press Enter.

The display shows the next Partition (for example) U02:P02:

NO ACCESS

7. Repeat steps 4 to 6 to give the correct access to all four Partitions.

When you press Enter after changing access

for Partition 4 the top line of the display shows: U03:DURESS CODE

DISABLED

Don't forget to tell each user which Level key they must use for each Parti-

tion, or that keying in their access code followed by Enter sets the highest

Level assigned to their access code.

Setting Up a Duress Code

A duress code is a special access code used for emergencies only. After

entering a duress code the system does not allow access to any of the

special functions listed in section 4. In addition, the system will not let you

give User 01 a duress code.

1. Start menu 8.

2. Press Enter until the top line of the display shows "U01:CODE=".

3. Press A or B until the display shows the user number you wish to use

for the duress code (or key in the number directly).

The display shows (for example): U14:CODE =

****

4. Press Enter.

The display shows: U14:CODE=

5. Key in the duress code and press Enter.

The display shows: CONFIRM NEW CODE

6. Key in the duress code again.

When you key the last digit of the duress code

the top line of the display shows: U14:P01:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Scantronic 8136 Guía de usuario Pagina 33