Scantronic 8136 Guía de usuario descargar pdf (Pagina 21)

496339 Issue 1 21 of 44

7. Press Enter.

The display shows (for example): IDIS LOOP NO 1

PROG DEVICE Z009

If the display shows any other message, see "IDIS Programming Er-

rors".

8. Use the up and down arrow keys to select the correct loop number. The

system will change the zone number to the appropriate one for the

selected loop. For example:

IDIS Loop 1 contains zones 9 to 40, the display shows Z009

IDIS Loop 2 contains zones 41 to 72, the display shows Z041

IDIS Loop 3 contains zones 73 to 104, the display shows Z073

IDIS Loop 4 contains zones 105 to 136, the display shows Z105

9. Press Enter.

The display shows (for example): IDIS LOOP NO 2

PROG DEVICE Z041.

10. Use the up and down arrow keys to select the appropriate zone number.

(You can also key in a number in the range 09 to 40 (OR 136) to select

the zone number directly.) Press Enter to confirm your choice.

The display shows: IDIS LOOP NO 2

PLEASE WAIT

Followed by confirmation of the module's address,

for example: IDIS LOOP NO 2

DEVICE IS Z041

Note: An IDIS LIM contains the equivalent of five IDIS devices, numbered consecu-

tively. When programming a LIM the system automatically assigns a block of

five consecutive zone numbers. Therefore, program the first IDIS device in the

LIM to the lowest zone number. Do not try to program the other four de-

vices, the system will do it for you.

11. Disconnect programmed IDIS module/sensor.

12. Write the zone number on the device, so that it will be installed in the

correct position.

13. Repeat steps 4 to 12 for the other modules to be programmed.

14. Press Menu when IDIS programming is complete.

The display shows Menu 22.

8136 Programming for IDIS

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Sin comentarios

Scantronic 8136 Guía de usuario Pagina 21