Scantronic 808 Guía de usuario descargar pdf (Pagina 6)

Introduction

Page 4

The four LEDs on the right of the programming keys show you

that the system is set or unset. The left hand LED glows when the

system is full set, the second from left glows when the system is

part set. Note that the installer can disable these LEDs in order to

hide the state of the system. (The two right hand LEDs are never

used.)

Controls:

A Full sets the system.

B Part sets the system.

Unsets the system.

In menus: scroll up. In text editing: move cursor left

In menus: scroll down. In text editing: move cursor right.

If the bottom line of the display shows a “>” at the right,

pressing this key selects the submenu named on that line.

If the bottom line of the display shows “On” “Off” “yes”

“no” “I” (for include) “O” (for omit) then pressing this key

changes the value to its opposite.

Deletes characters when editing names.

Press this key to confirm a decision.

a) Moves the display to a higher level of the menu.

b) Press this key to abandon your decision when the

display shows “Are you sure Y/N?”

Press this key to gain access to the programming menus.

1 to 0,

*, #

Used when keying in user codes and telephone numbers.

Can also be used to key in text for names.

# When keying in text press # to change between capitals

or small letters.

Press these keys to start a PA alarm. (Press both at the

same time.)

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Sin comentarios

Scantronic 808 Guía de usuario Pagina 6