Scantronic 4603 Guía de usuario descargar pdf (Pagina 9)

496368 Issue 1 9 of 12

Fault Finding

Under normal operating conditions, the Fault and Alarm LEDs are dark (the

power LED glows while mains is on). The Walk Test LED flashes after a

preset number of operations to advise that a walk test should be carried out.

Any other LEDs glowing or flashing signify either a fault or alarm condition, as

follows:

Figure 4. Fault Finding Displays

Low battery on zone

detector. Replace battery.

Jamming present on zone 4.

Check for interfering radio

signals. Activate detector/

transmitter and enter user

code twice. If fault persists

then call Scantronic product

support.

Zone activated during exit

time or during re-arm

period after an alarm.

Enter user code twice.

Tamper on zone active

during exit time or during

re-arm period after an

alarm. Enter user code

twice.

Radio frequency blocked.

Call Scantronic technical

support.

Consecutive code

jamming detected. Illegal

attempts made to

establish system site

code.

4600

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Scantronic 4603 Guía de usuario Pagina 9